BERETTA SHOTGUN PARTS-104-SST INERTIA BLOCK SPRING C54221

SST INERTIA BLOCK SPRING

SCHEMATIC REFERENCE – 49, 94, 104 – 692BE49, SV10PREVAIL49, SV10PERENNIA49, 69249, 68294, S680104

PART NUMBER - C54221

Beretta shotgun part SST INERTIA BLOCK SPRING for 692BE, SV10PREVAIL, SV10PERENNIA, 692, S680, 682, S680

The SST Inertia Block Spring is in the Beretta`s shotgun trigger group. It is located in the inertia block “pawl” (called inertia block lever) and has a spring in it. The spring is one of four forces preventing the block from moving rearward. The other three forces are the pawl spring, the angle of the pawl to the inertia block rest “nub” which causes the pawl to have to be slightly lifted before it releases.

NOTE: It is recommended that all BERETTA PARTS be installed by a QUALIFIED and trained gunsmith.
Cole Gunsmithing Service Work Order Request Form

Below are some recommendations from Beretta for cleaning an over under shotgun:
Cleaning your Beretta over and under competition shotgun is important to keep it in good condition and ensure it functions properly. Here’s a guide on how to clean a Beretta over and under shotgun:
At the end of a hunting or shotting session, clean the shotgun and make sure the chokes are properly tightened. Metal surfaces on shotguns without protective surface treatment need to be cleaned thoroughly and lubricated after every use to protect against rust. Use a cotton cloth soaked in Beretta gun cleaner and a cleaning rod to remove firing residues from the barrels. Use a bronze brush if necessary. Always insert the cleaning rod into the cartridge chamber. Run a clean, dry cloth through the bores to remove detergent residues. Lightly oil the bores with Beretta gun oil on a clean cotton cloth.
Never apply too much oil. A buildup of oil will attract dirt, and this can interfere with the shotgun’s operation and reliability. lean the inner face of the receiver (especially the area around the firing pin holes) and oil lightly. Do not allow oil to enter the firing pin holes. The hinge pin area is a very important coupling area. The receiver and fore-end iron are subject to very high loads and if not properly oiled, could cause seizing of parts or shotgun malfunctioning. Always make sure these parts are lubricated, following the instructions provided. Carefully clean the outer surfaces of the shotgun to remove all traces of dirt, sweat and fingerprints. Apply a thin layer of gun oil (good quality) to the shotgun, using a soft cloth.

GREASE APPROPRIATE CONTACT POINTS.

WARNING… XCESS OIL OR GREASE CAN OBSTRUCT THE BORE, EVEN PARTIALLY; THIS MAKES FIRING VERY DANGEROUS AND CAN DAMAGE THE SHOTGUN AS WELL AS CAUSING SERIOUS INJURY TO THE SHOOTER AND BYSTANDERS.

COLE GUNSMITHING is the Worlds Largest Beretta Premium Shotgun Dealer!

Buy shotguns and shotgun parts from the Worlds Largest Beretta Premium Shotgun Dealer!